LED-Tube-Sensor

There are different versions of LED tubes with built-in sensor. Tubes with PIR sensor (infrared sensor) detect heat radiation in motion. Such tubes, however, cannot be installed in diffuser luminaires as the diffusers block heat detection. We therefore recommend LED tubes with integrated radar sensor for installation in diffuser luminaires. Just use 2.4 GHz tubes, good tubes like METOLIGHT use 5.4 GHz as detection frequency. Such self-switching tubes are ideal in car parks, corridors, elevators and other areas where full light is not always required.

METOLIGHT LED Tube PIR or RAD - with motion sensor

METOLIGHT LED tubes with integrated infrared or microwave sensor save even more energy than "normal" LED tubes, since in the automatically dimmed state they only consume approx. 20% of the power as in the fully switched-on state. The -ADJ version also allows individual setting of the fallback time and the dimming state. The integrated sensor detects all movements within a radius of approx. 8 m and switches the light output to 100% in less than 1 second. These LED tubes are ideal for use in car parks, underpasses, basements, corridors, etc. where low ambient lighting is sufficient as long as nobody is there. Like all METOLIGHT LED tubes, the tubes of the PIR/RAD series are also equipped with the SCE (Safety-Connect-Electronics) circuit: no current entrainment, no risk of electric shock. Before replacing the tube, the lamp must be disconnected from the power supply, as otherwise the ballast may discharge in a flash when the tube is inserted and damage the LED tube.
LED-Tube-Sensor
LED-Tube-Starter

METOLIGHT fused LED Tube-Starter for led tubes Type VDE, SCE and ECO

1,95 EUR
 
plus 19% tax excl. Shipping costs
Show 1 to 15 (from a total of 15 products)